Here, our Servr IP address will be 172.16.0.1 and the mask will be 255.255.255.0. This is the IP address and subnet mask of the Server. We also assign this value on this screen.Īfter this configuration, we should not forget to “ on” our DHCP Service at the top and then, we add our DHCP Pool to the configuration with “ add” button.Īfter DHCP Services configuration on DHCP Server, we will configure one more thing on this DHCP Server. And for this example, we have created 254 IP for our IP Pool. DHCP server will start IP asssignition with this IP. After that we will configure the starting IP and Subnet Mask. Beside, we will configure the Default Gateway, DNS Server IP addresses. For this configuration example our DHCP Pool’s name is “ IPCisco Pool”. In the Services tab of Server, we will go through the DHCP at the left hand. This server will give IP addresses to our devices who are connected to the Access Point.

In this step, we will configure our DHCP Server in the WLAN. Simple, when we say this type of IP address in a device, we can say that it has no IP address. These addresses are from the block “ .x/25”. This is APIPA (Automatic Private IP Addressing) addresses. Because, at the beginning if there is no Static IP Configuration and no DHCP, an IP from a special block is assigned to the devices. For now, chekcing only one of them is enough. We will check the IPm addresses of the laptops. You can also check GNS3 COnfigurations Lab Page Smartphone devices in Packet Tracer connects to Access Points (AP) by default. Then, we power on the laptop again.Īfter this processi each laptop connects to th wireless Access Point in Packet Tracer. So, in each laptop, we should turn off the laptop, remove the classical Ethernet, instead of it we place Wireless Interface Card (WPC300N). To involve in a wireless network, we should have wireless interface card. Place Wireless Interface Card to Laptopsīy default laptops has classic Ethernet card.Now, let’s sumamrize what will we do for Packet Tracer WLAN Configuration : You can reach all Cisco packet tracer config files on Cisco Packet Tracer Lab Page. Smartphones are everywhere, even in Cisco Packet Tracer for many years : ) In this lesson we will focus WLAN Packet Tracer Configuration and we will learn How to Configure a WLAN on Packet Tracer.įor Our WLAN Configuration on Packet Tracer, we will use the below topology that is consist of one One Wireless Access Point, One Server, Three Laptops and One Smartphone. It is not an healthty life but they are in our lives. Even now, you are in many of these wireless signals. Everywhere there are a lot of wireless networks. WLANs (Wireless LANs) are very common in today’s World.

Cisco packet tracer cable modem example